英语翻译Total glucose concentration was measured by phenolvitriol method.One milliliter of the supernatant for each treatment was accurately taken and filled into a 10 ml cuvette.Then 0.5 ml,6% phenol was added into the cuvette and shaken-up.Then

英语翻译Total glucose concentration was measured by phenolvitriol method.One milliliter of the supernatant for each treatment was accurately taken and filled into a 10 ml cuvette.Then 0.5 ml,6% phenol was added into the cuvette and shaken-up.Then
英语翻译
Total glucose concentration was measured by phenolvitriol method.One milliliter of the supernatant for each treatment was accurately taken and filled into a 10 ml cuvette.Then 0.5 ml,6% phenol was added into the cuvette and shaken-up.Then 2.5 ml vitriol was filled into the mixture in cuvette,shaken-up and stand for 30 min at room temperature.At last,absorbance values were recorded by a 722 spectrophotometer at the wavelength of 490 nm.At the same time,the wash solution was measured as blank control in an identical way.

英语翻译Total glucose concentration was measured by phenolvitriol method.One milliliter of the supernatant for each treatment was accurately taken and filled into a 10 ml cuvette.Then 0.5 ml,6% phenol was added into the cuvette and shaken-up.Then
总的葡萄糖浓度用苯酚-硫酸法测量.每次治疗的上清液每一毫升都要准确提取,注入到10ml的试管中.然后,将0.5毫升6%浓度的苯酚加入试管摇匀.然后2.5毫升的硫酸倒入试管混合,摇匀并在常温下放置30分钟.最后,用波长为490转矩的722分光计测量光值.同时,测量清洗液作为空白对照.

总葡萄糖浓度测定phenolvitriol方法。1毫升的上清液为每个治疗准确地入10毫升试管。然后0.5毫升，6%苯酚加入到试管和shaken-up。然后2.5毫升硫酸的混合物填充到试管，shaken-up站30分钟，在室温下。最后，吸光度值记录了一个722分光光度法在波长490纳米。同时，洗涤液测量作为空白对照在相同的方式。...

全部展开

总葡萄糖浓度测定phenolvitriol方法。1毫升的上清液为每个治疗准确地入10毫升试管。然后0.5毫升，6%苯酚加入到试管和shaken-up。然后2.5毫升硫酸的混合物填充到试管，shaken-up站30分钟，在室温下。最后，吸光度值记录了一个722分光光度法在波长490纳米。同时，洗涤液测量作为空白对照在相同的方式。

收起

jkhkjnnnkkhnmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmnnnnnnnnnnnnnnmmnllluhbnjmmmmnmnbbbbbbbbbbbbb...

全部展开

jkhkjnnnkkhnmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmnnnnnnnnnnnnnnmmnllluhbnjmmmmnmnbbbbbbbbbbbbbbn,,,,,,,,,,,,,,,,,,,,,,,,,mmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmmm

收起

我不是化学专业人士，所以解释有些偏差哈… 总的葡萄糖糖浆浓度可以用硫酸酚（我想应是硫酸和酚的混合液）检测。一毫升上清液被精准的吸取并注入一个10毫升的刮器（估计应是试管）中以用于每次治疗。随后取0.6毫升，浓度为6％的硫酸注入一个试管，振荡（轻微摇晃），然后，取2.5毫升的酚注入装有硫酸的试管，混合，振荡并在室温下置放30分钟。最后，其吸光度标准值被记录在一个722分光光度计上，显示波长为490纳...

全部展开

我不是化学专业人士，所以解释有些偏差哈… 总的葡萄糖糖浆浓度可以用硫酸酚（我想应是硫酸和酚的混合液）检测。一毫升上清液被精准的吸取并注入一个10毫升的刮器（估计应是试管）中以用于每次治疗。随后取0.6毫升，浓度为6％的硫酸注入一个试管，振荡（轻微摇晃），然后，取2.5毫升的酚注入装有硫酸的试管，混合，振荡并在室温下置放30分钟。最后，其吸光度标准值被记录在一个722分光光度计上，显示波长为490纳米。同时，沉淀物溶液亦要用相同的方法测量作为空白对照。（希望及时采纳）

收起